F-1 Test cycle....
To set up:
1- Close detergent cup and
latch door
2- Press two pads at same
time time F-1 Appears in display
3- Press start
| Code |
Function |
Time |
Check for |
| 55 |
Displays on |
5 sec |
All digits, words,
light on |
| F |
Water fill |
65 sec |
Water valve on,
motor runs |
| DA |
Detergent
cup trip |
30 sec |
Detergent motor on |
| C1 |
Circulate
heat to 13% |
30 min |
Motor on heater on
530W heater off at 132ºF water |
| CO |
Circulate |
30 sec |
Motor on |
| rA |
Rinse
agent dispenser trip |
30 sec |
Detergent motor on |
| c2 |
Circulate
heat to 145 F |
30 min |
Motor on heater on
at 950W water offat145ºF water |
| PO |
Pump out |
406 sec
maximum |
Drain solenoid on
for 5 sec pump out until water gone or to 405 sec |
| Dr |
Heater
dry |
34 min |
Heater on at 475w (25 sec on -
25 sec off) |
Notes:
1- Press start pad to shorten
time
2- Caution: allow full time
for FDA and rA
3- To freeze function press
"Normal" wash pad to unfreeze press "Start FWD"
To use F-1 with door apart:
1- Wedge detergent pad to
shorten time
2- Tape door switch closed.
3- Remove wedge & tape
after check
Problem Codes
| Display |
Problem |
| C2 |
Drain
over 405 sec, cycle stops |
| C3 |
Will not
go into drain, cycle stops |
| C4 |
Too much
water, cycle stops |
| C5 |
No water
in tub or inlet to pump clogged, cycle stops |
| C6 |
Water
temp. too low after 20min. extension |
| C7 |
Temp.
sensor inoperative no water heat |
| C8 |
Detergent cup
blocked from opening |
