| Display Code |
Description |
Trigger |
Action to be taken |
| DO |
Door Open |
Door
monitor switch in door lock mechanism is not able to communicate to the
control board is open. |
1.Make
door is closed.
2.Check for loose wire connections
at switch and/ or machine control board.
3.Check for failed door monitor
switch.
4.Check inputs and outputs at
machine control board.
5.Replace responsible component. |
| FL |
Failed to
look |
Door lock
monitor switch in door lock mechanism unable to communicate to control
board the door is locked. |
1.Check
wire connections in harness leading from machine control board to door
lock mechanism.
2.Check solenoid and door lock
enable switch in door lock mechanism.
3.Replace responsible component. |
| LO |
Door
failed to unlock |
Door lock
monitor switch does not indicate to the machine control board that the
solenoid in the door lock mechanism retracted and unlock the door. |
1.Check
for debris inside inside the door lock mechanism, which may be jamming
the lock solenoid.
2.check wire connections in harness
leading from machine control board to door lock mechanism.
3.Check the door lock monitor
switch for welded contacts.
4.Replace responsible component. |
| Lr |
Locked
Monitor Rotor |
Based in
signal information from motor control board, the machine control board
senses the motor is not turning when requested to run |
1.Run
motor control board diagnostic test.
2.Check motor control board for
damaged components.
3.Check wire connections in harness
leading from machine control board to motor control board.
4.Replace responsible component. |
| ND |
No Drain |
Machine
control board monitors water level in washer during and at the end of
pump out. If wash level does not reset pressure switch, it will see
water left in the washer. |
1.Check
for pump/drain restriction.
2.Check pump operation.
3.Check pressure switch for open
contacts.
4.Check inputs and outputs at
machine control board.
5.Replace responsible component. |
| NF |
No Fill |
Washer
does not turn on water valves to fill washer with water. |
1.Is the
water turned on?
2.Check inlet hose screens for
restriction.
3.Check wire connections in harness
leading from machine control board to pressure switch.
4.Check water valve.
5.Check inputs and outputs at
machine control board. |
| OD |
Opened
Door not sensed by machine control board |
Machine
control board did not see the door open prior to the beginning of a new
wash load. |
1.Open
and close door, then restart washer.
2.Check wire connections in harness
leading from machine control board to door lock mechanism.
3.Check door monitor switch for
welded contacts.
4.Check inputs and outputs at
machine control board. |
| Sd |
Suds |
Machine
has detected high levels of suds. |
The
machine will alter it's cycle for this situation. Use an HE detergent or
cut down on the amount of detergent slightly. This can be more likely on
towel loads, consider HE detergent especially for these loads. |
| PF |
Power
failure |
Power to
the machine has been lost during the last cycle. |
This may
occur on start up of a new machine due to factory testing. |
