Some tips and procedures on replacing a common Whirlpool evaporator fan motor....
Disconnect power before servicing!!
Remove the screws and the back wall of the freezer
Remove fan motor
Install the 2 mounting grommets and the 2 sleeves from the fan motor kit onto the new motor. NOTE: On models with foam-insulated cabinets and special screw grommets - Do not use the 2 sleeves provided in the kit to mount the motor.
Mount push-on fan blade onto the motor
Connect wire leads to the new motor
Mount the new motor to the liner with the 2 screws provided in the kit. NOTE: Porcelain liner models may require breaking off the ends of the mounting brackets.
Plastic liner models do not need the parts in this kit.
IMPORTANT DISCLAIMER: The Author of this web site assumes no responsibility for inconveniences or damages resulting from use of the information he supplies. The consumer or reader is individually responsible for his or her use of the information supplied and uses this information at their own risk. The author of this site has no liability for errors, omissions, or any defects whatsoever in the information or instructions, or for any damage or injury resulting from the utilization of said information or instructions....