|
Whirlpool Thin Twin -
Accessing the dryer to replace the belt....
Disconnect the
power.....PLEASE!
Look under each side if the control panel
on the bottom. There you will find 2 1/4 inch screws....unscrew these about 6
full turns...this lowers the hooks that hold control panel in place...it is
hinged and will flip down...sometimes you have to pry it down gently!
Once the panel is down you disconnect the white wire connector going to the door
switch and remove the 2 screws holding the front cover on....then carefully lift
up on the front cover to unhook it from the 2 hooks on top...kind of slides up
and out. The tub is going to stay inside and drop down...the front cover supports
the tub. At this time you can remove the tub and clean out all the lint...(recommended)
Putting the front cover back on is a little tricky...you have get it attached on
the top hooks and then pick up on the tub to put it on the bearing ring in the
front cover ..then put the 2 screws back in...3 hands are nice to have now.
Compliments from Mike the Applianguy
| |
It
measures DC Voltage, DC Current, AC Voltage, Resistance. It tests Diodes and
Transistors. It even has a buzzer for an audible continuity test! You can't buy
a toy this cheap (and this meter even comes with a battery)!
|
