Get Repair Parts at

Toddler Bo Peep Costume
Toddler Bo Peep Costume
This is a Toddlers Bo Peep Costume.[Read More]

Deluxe Toddler Alice Costume
Deluxe Toddler Alice Costume
Time For Tea! Who is ready for a tea party? Alice is! Did you invite the Mad Hatter? We hope that you did because...[Read More]

Fall is here! Is your outdoor power equipment ready?

Make sure your equipment is in top shape for the season change with our top-rated OEM replacement parts and expert DIY Repair Help!

Browse thousands of parts from dozens of brands to find what you need today.

Shop Outdoor Equipment Parts

Find Outdoor Equipment Repair Help

trimmer saw

trimmer saw

Kenmore 665 model dishwasher error codes:

Reference Model: Kenmore 665.######## or Kenmore Elite dishwasher

These error code explanations can help you perform Kenmore dishwasher model 665 troubleshooting when you see a light (or lights) blinking on the display.

Find the Kenmore 665 or Kenmore Elite dishwasher error code displayed on the control panel.

Kenmore and Kenmore Elite dishwasher diagnostic codes no longer appear on the display once you resolve the problem that caused the code.

Code Meaning Possible Cause Possible Parts
Clean light blinks 7 times Heater circuit failure. Control didn't detect the expected rise in water temperature when the heating element was energized to heat water during the cycle Check the heating element and related components (wiring and control board) in that circuit Heating element, Electronic control board, Thermistor, Circuit wiring
Console light blinks rapidly The control detects a stuck button on the control panel A failed control panel or a bad electronic control board can cause this code. Check the buttons on the control panel using a volt/ohm meter. In most cases, the control panel needs to be replaced Control Panel, Electronic control board
Start/Resume light blinks slowly If the dishwasher door is opened or power is interrupted during the cycle, the dishwasher won't start again until the door is detected as closed and the Start/Resume button is pressed Check the door latch and switch assembly. A failure in the Start/Resume button also can cause this problem Door switch assembly, Control panel, Electronic control board
Clean light stays on The dishwasher won't start a new cycle unless it detects that the door opened after the previous cycle Turn off power to the dishwasher by shutting off the breaker and restarting. If that does not work, the door switch assembly is stuck and must be replaced Door switch assembly
Control lock LED is on but not accepting key presses Accidentally turned on or control detected keypad problem Press the Heated Dry key for 5-10 seconds to turn off control lock feature. If that doesn't work, replace keypad Keypad
Sanitized LED blinks at end of cycle Control could not confirm Sanitation water temperature was achieved The heating element must stay on for 10 minutes when heating water for the sanitation cycle and water temperature must reach 150 degrees. Check incoming water temperature. If incoming water temperature is below 120 degrees, the heating element may not heat the water to 150 degrees. If incoming water temperature is above 150 degrees the heating element may not stay on for 10 minutes so the sanitation error may occur. If incoming water temperature is okay, check the heating element for damage. Replace the heating element if it's damaged or it doesn't heat Heating element

Kenmore Dishwasher Repair Parts

Related Links

  1. Kenmore Dishwasher Adhesive 1
  2. Kenmore Dishwasher Adhesive 2
  3. Kenmore Dishwasher Cleaner 1
  4. Kenmore Dishwasher Cleaner 2