Frigidaire Dishwasher Fault Codes



Error Codes Tips for some Frigidaire Built Dishwashers



Reference Model: None


Error Code Reason for the Code Possible Component to replace
uo Vent open 1) Check for vent operation verify it is not blocked. If blocked replace the vent

2) Possible control
uf Vent failure Replace vent fan
Er Membrane switch failure Replace keypad and consol assembly
CL Door switch open or door is open Door latch
hs hall sensor has failed on the wash motor Wash motor
PF Power has dropped or failed Check power connections
rA Rinse aid dispenser reed switch failure Replace dispenser
tu Turbidity sensor has failed Replace turbidity sensor and seal
Codes that are not Error codes
HO This is the notification that the unit is in a heat delay to allow the water to increase in temperature No component to be replaced, but recommend the homeowner check the incoming water temperature and run the faucet before starting the cycle
LO Rinse aid level is low in the dispenser No component to be replaced, refill rinse aid dispenser
PF Outage or reduction in the voltage to the unit No component to be replaced, but check to ensure the power is on, open and close the door once and this will go out

Frigidaire Dishwasher Parts



Related Links

  1. Frigidaire Dishwasher Gasket or Seal
  2. Frigidaire Dishwasher Control Board
  3. Frigidaire Dishwasher Pump