Haier HDY dryer error codes:


Reference Model: None


These error code explanations can help you diagnose a problem with your Haier HDY series dryer.



Code Meaning Possible Cause Possible Parts
E1 Door is open Close the dryer door if open. If the door is closed when the code is displayed, unplug the dryer and reconnect the wire harness on the door switch. Replace the wire harness if damaged. If the wire harness is okay, replace the door switch Door switch, Wire harness
E2 Not heating If the dryer actually doesn't heat, unplug the dryer and replace any defective heating system components. If the dryer does heat, measure the temperature sensor resistance using a volt/ohm meter. If the resistance isn't 10K ohms at 72 degrees F, replace the temperature sensor Heating system components, Temperature sensor
E3 Load is wet at end of cycle If the dryer doesn't heat, unplug the dryer and replace any defective heating system components. If the dryer heats, clean the lint screen because decreased air flow due to a clogged lint screen prevents the load from drying. Clear the exhaust vent duct system of clogs Heating system components
E5 Temperature sensor is defective Unplug the dryer and measure the temperature sensor resistance using a volt/ohm meter. If the resistance isn't 10K ohms at 72 degrees F, replace the temperature sensor Temperature sensor



Dryer Repair & Maintenance Parts



Related Links

  1. Shop Haier Dryer Parts
  2. Shop Appliance Cleaners Parts
  3. Shop Dryer Venting Parts
  4. Shop Laundry Accessories Parts