|
Maytag Dishwasher Repair Aid....
Always remember Electricity is dangerous and should be treated with respect. Please pick a topic by Make and or problem...hope you find this helpful :-)
Some older Maytag dishwashers have a drive belt that can break, slip, or make a terrible noise when it is ready to let go. This belt can stretch as well and then it may "fly" off, especially in the drain mode. The motor and pump pulleys are off-set so that not only does the belt go around and around it turns using the whole surface of the belt, that is why they use a belt dressing on the belt. The dressing lubricates the belt so it can roll between the pulleys. You will need to remove the access panels to get at the belt area.A belt replacement tip from Fyxxer.... One easy way I have found to replace the belt on an older
Maytag D/W.
Maytag dishwasher leak - On the plastic liner Maytag dishwashers a common problem area has been the small gasket on the soap door latch. This gasket wears out and leaks water between the inner and outer panels and onto the floor. A grommet and latch kit can be purchased to correct this type of leak.
IMPORTANT DISCLAIMER: The Author of this web site assumes no responsibility for inconveniences or damages resulting from use of the information he supplies. The consumer or reader is individually responsible for his or her use of the information supplied and uses this information at their own risk. The author of this site has no liability for errors, omissions, or any defects whatsoever in the information or instructions, or for any damage or injury resulting from the utilization of said information or instructions....
|
Soap cup door latch and gasket kit. *Bad gasket is a common cause for a door leak
Silverware basket with cover for small items, gray
Belt length 25 3/8”, width 1/4”, characteristics, clear, round
Dishrack clip for adjustable peg
Dishwasher single coil water inlet valve with bracket
|
|